Rahul Trading Company

Description:-
Lokfix S  is a fast setting, premeasured, two part filled polyester resin grouts for application at temperatures between 8 deg C to 27 deg C.

Main uses

• Lokfix S used for high strength corrosion resistant anchoring of bolts and bars from 12 - 51mm diameter into concrete, rock, masonry or brickwork where high speed of installation and early application of load is required.
• Permanent installation of reinforcement starter bars, foundation bolts, base plates, balustrading, barriers and safety fences, railway tracks, tie-back anchors, reinforcement dowelling abutments, ground anchors for towers, cranes, dock sills.

Advantages

• Rapid setting & strength gain
• Vibration resistant
• Corrosion resistant
• Non expansive
• Can be placed under water

Description:-
Lokfix is a two-component polyester resin anchoring grout, meeting the requirements of BS EN 1504-6: Anchoring of reinforced steel bars.

Main uses

• Supplied in pre-measured quantities, the material cures quickly to give consistent, high performance anchorages. The two versions of Lokfix available are :
• Lokfix S : Pourable grade, 25 minute gel time at 20°C for use in vertical down holes where the hole is 8 to 40 mm greater in diameter than the bar.
• Lokfix P : Thixotropic grade, 25 minute gel at 20°C for use in overhead or horizontal holes where the hole is up to 25 mm greater in diameter than the bar. The thixotropic nature of Lokfix P reduces flow of grout out of the hole.

Description:-
Conbextra GP2 is supplied as a ready to use dry powder. The addition of a controlled amount of clean water produces a free flowing, non-shrink grout for gap thicknesses up to 100mm.

Main uses

• Conbextra GP2 is a blend of Portland cement, graded fillers and chemical additives which impart controlled expansion in the plastic state whilst minimising water demand. The low water demand ensures high early strength. The graded fi llers are designed to assist uniform mixing and produce a consistent grout.

Advantages

• Gaseous expansion system compensates for shrinkage and settlement in the plastic state
• No metallic iron content to cause staining Pre-packed material overcomes onsite batching variations
• Develops high early strength without the use of chlorides
• High ultimate strength ensure the durability of the hardened grout
• Free flow ensures high level of contact with load bearing area.